JVC GR-SZ5000 Instructions Manual page 41

ORIGINAL TAPE (camcorder)
1 3
IN OUT IN OUT
EDITED TAPE (VCR)
STOP
SUPPLEMENTAL INFORMATION ON THE REMOTE CONTROL
Player (JVC VCR)
To Editing cable
R.A.EDIT (provided)
To
PAUSE IN
2
IN OUT
EDIT
Using the RM-V704U/V700U, it is also possible to perform
deck-to-deck Random Assemble Editing. The playback
deck must be an R.A. Edit-capable JVC VCR. The recording
AV OUT
deck can be...
How to use:
AV IN
— Connect the playback deck and RM-V704U/V700U as
— Set the RM-V704U/V700U to correspond to the brand
Recording deck
— For Random Assemble Editing procedure, please refer to
Notes:
RM-V704U or
RM-V700U
(provided)
AUTOMATIC EDITING TO VCR
ENGAGE VCR'S RECORD–PAUSE
MODE
1
Point the remote control toward the VCR's infrared
sensor and press VCR REC STBY, or manually
engage the VCR's Record-Pause mode.
BEGIN AUTOMATIC EDITING
2
Press EDIT on the camcorder, and the previously
selected scenes are copied to the VCR in the
specified order.
END AUTOMATIC EDITING
3
When all selected scenes have been copied, the
camcorder and VCR enter the still or pause mode.
Press STOP on both units. To make the R.A. Edit
counter display disappear, press R.A. EDIT.
•When finished editing, be sure to disconnect the
editing cable and the audio/video cable.
NOTES:
If you performed step 1
CONNECTIONS"), keep the remote control pointed at
the VCR during editing.
The on-screen display only appears while the
camcorder searches for each scene.
There may be noise at in- or out-points on the edited
tape with certain VCRs.
a VCR other than JVC, or
a JVC VCR which has neither a Remote PAUSE nor an
R.A. EDIT connector
shown on the left.
of the recording deck. (
the instruction manual of the JVC VCR you are using as
the playback deck.
RM-V704U/V700U cannot be used to control the
playback deck.
RM-V704U/V700U is capable of controlling basic
operations of the recording deck. While pressing VCR
CTL, press PLAY, STOP, PAUSE, FF or REW for these
functions. (Not possible with some brands and models).
Other buttons cannot be used.
To put the recording deck in the Record-Pause mode, use
the controls on the recording deck itself.
on page 39 ("MAKE
C
pg. 38)
41