How To Install The Wheels - Murray 40508x92A Instruction Book

HOW TO INSTALL THE WHEELS

If the wheels must be removed for service, make sure they are
installed as follows.
Front Wheel
1. Make sure the valve stem is to the outside of the tractor. Slide
the front wheel on the spindle (See Figure 33).
2. Fasten the front wheel with washer and cotter pin. Bend the
ends of the cotter pin apart to keep the front wheel on the
spindle.
3. If your model has hub caps, install the hub caps. Make sure
the washer hold the hub caps in place.
Rear Wheel
1. Mount the square key in the key slot (See Figure 34).
2. Install the washers and spacer onto the axle as shown in
Figure 34.
3. Make sure the valve stem is to the outside of the tractor. Align
the slot in the rear wheel with the square key. Slide the rear
wheel on the axle.
4. Fasten the rear wheel with washer and e–ring.
5. If your model has hub caps, install the hub caps. Make sure
the washer hold the hub caps in place.
F–000704L
MAINTENANCE
Hub Cap
Valve Stem
Rear Wheel
Washer
E–Ring
30
Cotter Pin
Washer
Washer
Washer
Washer
Valve Stem
Spindle
Front Wheel
Figure 33
Square Key
Key Slot
Axle
Spacer
Figure 34