How To Install The Seat; How To Assemble The Steering Wheel - Murray 40508x92A Instruction Book

HOW TO INSTALL THE SEAT

Use the fasteners shown below to install the seat. The fasteners are
shown at full size.
(A)
94160
1. Carefully remove the plastic bag from the seat.
2. Align the holes in the seat hinge to the holes in the seat
(Figure 1). Fasten the seat to the seat hinge with the fasteners
as shown.

HOW TO ASSEMBLE THE STEERING WHEEL

Fasteners are not required to assemble the steering wheel. Attach
the steering wheel as follows:
1. Make sure the front wheels point forward.
2. Look at the hub of the steering wheel. Make sure the locking
clip is in place inside the hub.
3. Slide the cover over the steering post (Figure 2).
4. Slide the steering wheel onto the steering post. Push on the
steering wheel. The steering wheel will lock onto the steering
post. Pull on the steering wheel. Make sure the steering wheel
is locked in place.
Some models have an optional decal in the parts bag. Attach
5.
the decal to the center of the steering wheel as shown.
F–000704L
ASSEMBLY
3.
(B)
17x47Z
Steering Wheel
11
Check the operating position of the seat. If the seat needs to
be adjusted, loosen the two wing bolts. Slide the seat forward
or backward along the seat adjusting holes as shown. Tighten
the wing bolts (A).
Decal (Optional)
Steering Post
Seat
Seat Hinge
Seat
Adjusting Hole
B
A
Figure 1
Hub
Cover
(Optional)
Figure 2