Table of Contents
Advertisement
Radio Operation
4.6
Tuning a station
1. Slide the function switch to the RADIO /AUX position.
2. Set the required band with the BAND selection switch.
To listen to an FM station in stereo set the function switch to
FM ST.
3. Tune the station by rotating the TUNING control.
When receiving an FM broadcast, fully extend the telescopic
antenna and angle it for the best reception.
For MW broadcasts, vary the position of the unit until the best
reception is located.
4. Adjust the volume to a comfortable listening level using the
VOLUME control.
4.7
Aux In Mode
It is possible to connect an external audio source like an MP3
player using a 3.5mm audio cable (not supplied).
1. Connect one end of the cable to the MP3 player headphone
output and the other end to the AUX input on the right hand
side of the unit.
2. Slide the function switch to the RADIO /AUX position.
3. Press
on the external audio source.
The volume output is affected by the volume level on the
source EG: MP3 player so make sure that is set to about
70-80% ( not too loud to avoid distortion ).
4. Adjust the VOLUME control on the unit to the required
listening level.
AUX /
RADIO
OFF
CD
MAX
VOLUME
FM ST
TUNING
AUX/
RADIO
OFF
MIN
MAX
VOLUME
MW FM FM ST
TUNING
CD
GPS02
Advertisement
Table of Contents
