Radio Operation; Tuning A Station; Aux In Mode - Goodmans GPSBT01 User Manual

Radio Operation

4.6

Tuning a station

1. Slide the FUNCTION (S) switch to the AUX/ RADIO position.
2. Set the required band with the BAND selection switch (R).
To listen to an FM station in stereo set the FUNCTION
switch to FM ST.
3. Tune the station by rotating the TUNING control (Q).
4. The built-in MW aerial and external FM pigtail aerial are
directional.
When receiving an FM broadcast, fully extend the pigtail aerial
and position it for the best reception.
For MW broadcasts, vary the position of the unit until the best
reception is located.
5. Adjust the volume to a comfortable listening level using the
VOLUME control (T).

Aux In Mode

4.7
It is possible to connect an external audio source like an MP3
player using a 3.5mm audio cable (not supplied).
1. Connect one end of the cable to the MP3 player headphone
output and the other end to the AUX input (O) on the back
of the unit.
1. Slide the FUNCTION (S) switch to the AUX/ RADIO position.
When the audio cable is connected the radio audio output
will be muted.
2. Press on the external audio source EG:-MP3 player.
The volume output is affected by the volume level on the
source EG: MP3 player so make sure that is set to about
70-80% ( not too loud to avoid distortion ).
3. Adjust the VOLUME control (T) on the unit to the required
listening level.
FUNCTION
OFF BT
CD AUX/RADIO
160 KHz x 10
108 MHz
BAND
TUNING
FM ST. MW
FM
160 KHz x 10
108 MHz
TUNING
FUNCTION VOLUME
OFF BT MAX MIN
CD AUX/RADIO
VOLUME
MAX MIN
BAND
FM ST. AM
FM
GPSBT01