Radio Operation; Tuning A Station; Aux In Mode - Goodmans 328763 User Manual

Radio Operation

Tuning a Station

4.6
1. Slide the function switch to the RADIO position.
2. Set the required band with the BAND selection switch.
To listen to an FM station set the function switch to FM ST.
3. Tune the station by rotating the TUNING control.
When receiving an FM broadcast, fully extend the telescopic
antenna and angle it for the best reception.
For MW broadcasts, vary the position of the unit until the best
reception is located.
4. Adjust the volume to a comfortable listening level using the
VOLUME control.

Aux In Mode

4.7
Connect an external audio source like an MP3 player using a
3.5mm audio cable (not supplied).
1. Connect one end of the cable to the MP3 player
headphone output and the other end to the AUX input on
the left hand side of the unit.
2. Slide the function switch to the CD/AUX/BT. position (when
the 3.5mm audio cable is connected the AYX mode
becomes active).
3. Press on the external audio source.
The volume output is affected by the volume level on the
source EG: MP3 player so make sure that is set to about
70-80% ( not too loud to avoid distortion ).
4. Adjust the VOLUME control on the unit to the required
listening level.
CD/
AUX
AUX/BT.
RADIO
CD/
AUX
AUX/BT.
CD/
AUX
AUX/BT.
RADIO
AUX
RADIO
FM ST. MW
CD/
AUX/BT.
RADIO
328763