Preliminary Advice; User Manual; Remote Control - Gemini 953 Installation And Use Manual

1.0 - PRELIMINARY ADVICE

Dear Customer,
th e present manual illustrates the top version of the alarm system; not all
functions, electrical connections etc. will therefore apply to all models.
Before installing, you must identify your alarm model and refer to it for the
correct instructions .
953: Nr. 2 remote control, Nr. 1 electronic key and self-powered.
953.02: Nr. 2 remote control, joint LED and self-powered.
952: Nr. 2 remote control, joint LED and not self-powered.
The following signs, intended for the installer or the user, indicate particular
functions or connections as follows :
WARNING
!
It shows a real risk of severe damages to the vehicle and to its alarm
system in case these instructions are not complied with.
CAUTION
It shows a risk of damages to the system or of any operative malfunctions
of the system in case these instructions are not complied with.
We also recommend you to always wear your crash helmet, keep lights on and
observe the speed limit, when riding your motorbike.
Enjoy your reading... and have a nice trip!

USER MANUAL

2.0 - D ESCRIPTION OF ALARM
CONTROL DEVICES
In order to use the alarm system, it needs to receive commands by the user;
this can be done by means of remote controls and electronic keys.
A further possibility to deactivate the system, when needed, is given by the
PIN-CODE.
Such procedure can be activated by means of the ignition key of the vehicle
itself and is detailed in the relevant chapter

2.1 - REMOTE CONTROL

The remote control is the main user "interface"; therefore, we recommend you
to acquaint yourself with it.
The remote control buttons activate several functions that differ according to
the operational condition and the alarm program.
Please also note that buttons have been made different in form, in order to be
better recognized and identified.
The alarm activation/deactivation button is dotted, while the siren button is
smooth .
To prevent problems with the remote control, it has been provided with a device
that will signal the charge condition of the batteries inside.
During normal use of the remote control, when you press a command button
the green transmission LED will light up with a steady light.
If the battery charge drops below the level needed to assure correct operation
of the remote control, when you press a command button the green
transmission LED will blink, advising you that it is time to replace the batteries
!
Button Nr.1: Alarm system
arming/disarming .
!
Anti hijacking function
activation.
!
Hazard function activation.
Button Nr.2:
!
Anti hijacking function
activation.
!
Panic alarm
activation/deactivation.
!
Siren control during alarm
conditions.
!
Siren control during system
activation .
!
Shock sensor programming,
and regulation.
SYSTEM
.
.
Signalling
LED
Button N.1
Button Nr.2