Accessories Positioning; Perimetral Push-Button (Optional); Control Unit Sealing - Gemini 953 Installation And Use Manual

17.0 - ACCESSORIES POSITIONING

18.0 - CONTROL UNIT SEALING

17.1 - RECEPTACLE FOR ELECTRONIC KEY
The receptacle with buil in LED (or the only LED) must be set up where the user
can easily see and access to it.
Please remember that the LED represents the first deterrent against an ill-
intentioned person.
Before drilling the plastic parts of the vehicle, please check the handlebar with
respect to the steering lock on ON.
You will thus avoid putting the LED or the slot in such a way as to be covered by
Sealing the control unit
the handlebar when the vehicle is parked.
Should you put them otherwise, we always recommend paying a particular
attention during the drilling phase, not to damage the vehicle.
The fastening drilling diameter for the electronic key slot is equal to 13mm.
The fastening drilling diameter for the LED slot is equal to 10mm .
P ut the electronic key
receptacle with
integrated LED in
such a way so that
they can be easily
seen and found .
Electronic key
Control unit sealed

17.2 - PERIMETRAL PUSH-BUTTON (OPTIONAL)

This push-button, if fitted, must be placed in such a way as to detect any saddle
or trunk opening but it must not be found from their outer part.
The alarm threshold adjustment shall be carried out very carefully, to prevent
from any false alarm.
T he push-button terminal to be earthed must not be connected to the frame as
it is not connected to the battery negative pole.
This connection can be made to a cable, which constantly provides for a
negative pole (ex.: turn signal lamp earth).
If the under-seat push-button is not installed, the GREEN/BROWN wire is free.
We suggest you to keep this wire available for other possible uses .