Alarms - Macurco CM-E1 User Instructions

Carbon monoxide detector
Hide thumbs Also See for CM-E1:
Table of Contents

Advertisement

The CM-E1 continuously monitors the ambient air at the sensor. If the CM-E1 measures levels of CO greater than the
danger level, the RED light will turn on, the Alarm Relay will switch to actuate the alarm circuits in the control panel, and
the buzzer on CM-E1 units will sound. The CM-E1 is programmed to alarm if the danger levels of carbon monoxide are
exceeded, which are time and concentration-related. The alarm points are: 70 ppm of CO after 60 to 240 minutes, 150
ppm of CO after 10 to 50 minutes, and 400 ppm of CO after 4 to 15 minutes, in accordance with the provisions of UL
Standard 2034.
Individuals with certain medical problems may consider using warning devices that provide audible and visual signals for carbon
monoxide concentrations below 30 ppm. (UL 2034)

ALARMS

Immediately exit the environment if it causes an alarm condition on the detector. Failure to do so may result in sickness or death.
INSTALLER NOTE: It is required that the following UL information below be posted near the control/alarm panel or a
copy provided to the customer.
WARNING
(CO) which can KILL YOU. If alarm signal sounds:
1) Operate the reset/silence button;
2) Call your emergency services (____________________) [fire department or 911];
3) Immediately move to fresh air - outdoors or by an open door/window. DO A HEAD COUNT TO CHECK
THAT ALL PERSONS ARE ACCOUNTED FOR - DO NOT RE-ENTER PREMISES NOR MOVE AWAY
FROM THE OPEN DOOR/WINDOW UNTIL THE EMERGENCY SERVICES RESPONDERS HAVE ARRIVED,
THE PREMISES HAS BEEN AIRED OUT, AND THE ALARM REMAINS IN ITS NORMAL CONDITION
4) After following steps 1 - 3, if your alarm reactivates within a 24-hour period, repeat steps 1 - 3 and
call a qualified technician (____________________) to investigate for sources of CO from fuel burning
equipment and appliances, and inspect for proper operation of this equipment. If problems are
identified during this inspection, have the equipment serviced immediately. Note: Any combustion
equipment not inspected by the technician, consult the manufacturers' instructions or contact the
manufacturer directly for more information about CO safety and the equipment
Make sure that motor vehicles are not, and have not been operating in an attached garage or adjacent
to the residence. (UL 2034)
The following symptoms are related to CARBON MONOXIDE POISONING and should be discussed with ALL members of the
household:
Mild exposure: Slight headache, nausea, vomiting, fatigue (often described as "Flu-like" symptoms).
-
Medium Exposure: Severe throbbing headache, drowsiness, confusion, fast heart rate.
-
Extreme Exposure: Unconsciousness, convulsions, cardio respiratory failure, and death.
-
Many cases of reported CARBON MONOXIDE POISONING indicate that while victims are aware they are not well, they become so
disoriented they are unable to save themselves by either exiting the building or calling for assistance. Young children and household
pets may be the first affected.
! WARNING
! WARNING
: Actuation of your CO alarm indicates the presence of carbon monoxide
! WARNING
8

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents