JVC GR-DVX2 Instructions Manual page 21

Time Code
During recording, a time code is recorded on the tape. This code is to confirm the location of the
recorded scene on the tape during playback.
If recording starts from a blank portion, the time code begins counting from "00:00:00"
(minute:second:frame). If recording starts from the end of a previously recorded scene, the time code
continues from the last time code number.
To perform Random Assemble Editing (
portion is recorded partway through the tape, the time code is interrupted. When recording is resumed,
the time code starts counting up again from "00:00:00". This means the camcorder may record the same
time codes as those existing in a previously recorded scene. To prevent leaving a blank portion on a
tape, perform the procedure in "Recording From The Middle of A Tape" (
cases;
•After playing back the recorded tape, when
you shoot again.
•When power shuts off during shooting.
•When a tape is removed and re-inserted
during shooting.
•When shooting using a partially recorded tape.
•When shooting on a blank portion located
partway through the tape.
•When shooting again after already shooting a
scene and opening/closing the cassette cover.
NOTES:
The Time Code cannot be reset.
During fast-forwarding and rewinding, time code indication does not move smoothly.
When blank portion is recorded on a tape
Time code
00:00:00
Tape Already recorded scene
Shooting start point
Proper recording
Time code
00:00:00
Tape Already recorded scene
Shooting start point
pg. 60), time code is necessary. If during recording a blank
TC 12 : 34 : 24
Time code Time code
05:43:21 00:00:00
Blank
Shooting stop point Shooting start point
Time code Time code
05:43:21 05:44:00
New scene
Shooting start point Shooting start point
pg. 20) in the following
Display
Time code is displayed
during playback.
Minutes
Seconds
Frames
(25 frames = 1 second)
Newly recorded scene
Latest scene
21
EN