Table of Contents
Advertisement
IMPORTANT! In order to maintain operation of the
centrifugal cleaning system it must be regularly
maintained. Clean the air intake to the starter, the fins on
the flywheel, the space around the flywheel, inlet pipe and
carburettor compartment.
Winter use
Running problems can occur when using the machine in
the cold and snowy conditions caused by:
•
Too low engine temperature.
•
Icing of the air filter and carburettor.
Special measures are therefore often required:
•
Partly mask the air inlet on the starter to increase the
working temperature of the engine.
•
Preheat the intake air to the carburettor by using the
heat from the cylinder.
Temperature 0° ° ° ° C or colder
The cylinder cover is designed so it can be adjusted for
running in cold weather. Remove the plastic in the marked
circle, so that preheated air from the cylinder can pass
into the carburettor space preventing icing of the air filter,
etc.
For temperatures below -5°C and/or in snow conditions
there is also:
•
a special cover (A) for the starter housing
This reduces the flow of cooling air and prevents large
amounts of snow from being sucked into the carburettor
space.
38 – English
MAINTENANCE
IMPORTANT! If the temperature rises above -5 °C or 0
°C respectively the machine MUST be restored to its
normal set-up. The winter plug (B) is fitted in the empty
circle on the cylinder cover. Otherwise there is a risk of
overheating, resulting in severe damage to the engine.
Advertisement
Table of Contents
