Operating The Hydro Pumps; Jet Buttons; Clean-Up Cycle; Light Control Button - champion spas 108 Owner's Manual

o p E r aT i ng T h E hY d ro p um p (S )/J E T buTTon (S )
Activate the hydro jet pump(s) for maximum hydrotherapy jet action. Press the "Jets1" button
once for low speed, twice for high speed and a third time to turn the pump off. If you spa has
two hydro jet pumps, "Jets 1" will be a two speed pump, and "Jets2" will be a single speed
pump. Pressing "Jets2" once will turn the pump on high speed, pressing "Jet2" button again will
turn the pump off.
If either pump is left running, they will turn off automatically in 15 minutes if on High speed or
30 minutes if on Low Speed.
Also, note, if you spa is in READY MODE, pump 1 low speed may turn on for at least 1
minute every 30 minutes to detect the spa temperature (polling) and then to heat to the set
temperature if needed. When low speed turns on automatically, it cannot be deactivated from
the panel; however, the high speed may be started by pressing the "Jets1" button.

Clean-up Cycle

When "Jets1" is manually turned on, a "Clean-Up Cycle" begins 30 minutes, on low speed,
after "Jets1" is turned off. If your spa is equipped with an Ozone Generator, it will operate with
"Jets1" on low speed.
light button
The spa light is controlled using the LIGHT button. Press the LIGHT button once to turn the
spa light on, then again to turn the light off. The LIGHT button is also used in conjunction
with temperature(s) to navigate the system menus.
optional lEd blast™ or Splash™ lighting
If your spa is equipped with one or more of these lighting systems, see the operational features
and directions located in the Blast™ or Splash™ box, or contact your dealer for instructions.
16
C h a mp i o n Spa s ®
OWN E R 'S M A N UA L