Alfa Romeo Giulietta Owner's Handbook Manual page 123

SAFETY FUNCTIONS
When the engine is stopped by the Start&Stop system, if the dri-
ver releases his/her seat belt and opens the driver's or passenger's
door, the engine can be restarted only using the ignition key.
This condition is indicated to the driver by means of a buzzer and
by the symbol U blinking on the display (with a message, for
versions/markets, where provided).
ENERGY SAVING FUNCTION
(for versions/markets, where provided)
If, as a result of the engine automatic restarting, the driver does not
carry out any action on the vehicle for over 3 minutes, the Start&Stop
system stops the engine once and for all, to prevent fuel consump-
tion. In these cases, the engine can be restarted only using the ig-
nition key.
NOTE In any case, it is possible to keep the engine running by de-
activating the Start&Stop system.
IRREGULAR OPERATION
In the event of malfunction, the Start&Stop system is deactivated.
The driver is informed of the fault by the flashing U symbol (ver-
sions with multifunction display) or j symbol (versions with re-
configurable multifunction display). For versions/markets, where
provided, a message is also displayed. In this case, contact
Alfa Romeo Authorized Services.
STORING THE CAR
In the case of storage, special care must be taken to disconnect the
battery electrical power supply.
Proceed as follows: detach the connector A-fig. 83 (by pressing but-
ton B) from sensor C for monitoring the status of the battery in-
stalled on the battery negative pole D. This sensor should never
be disconnected from the pole except if the battery is replaced.
In case of battery replacement, always contact
Alfa Romeo Authorized Services. Replace the bat-
tery using a new one of the same type (HEAVY
DUTY) and having the same specifications.
fig. 83
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
119
A0K0179m