ENGINE COMPARTMENT
INSTRUCTIONS
STEP ONE: IF YOU HAVE NOT DONE SO ALREADY,
DISCONNECT THE BATTERY.
STEP TWO: During the next steps you'll be installing the condenser, drier, and
routing the high/low pressure lines and the liquid line. Since much of this is
installed in the OEM location for the condenser, you'll need to remove the
center grill section, horn(s), and latch support assembly
(see figure 33). Be sure to retain all the mounting screws –
you'll reinstall these pieces in the exact reverse order
with the OEM screws.
www.classicautoair.com • 866.435.7801 • PAGE 24
FIGURE 33