Remove The Heater Control Head From The Dash - Classic AutoAir Mustang 1969 Installation Manual

Remove The Heater Control Head From The Dash.

1) There are three OEM screws that hold your control head to the dash, one on
the lower side and two on the upper. Remove and retain these screws. Remove
the control head assembly (see figure 7).
2) Remove the OEM blower switch knob. Retain the screw, you will use it again
shortly. Remove the control cables and the original blower switch and set aside
(these will not be reused, see figure 8).
3) Attach the new blower switch bracket to the top part of the back of the face
plate (see figure 9-10), utilizing the OEM screw, and then attach the blower
switch to the bracket with the two supplied #6 - 20x3/8" screws. Reinstall the
switch knob.
Retain this
OEM screw
FIGURE 8
(OEM switch
not reinstalled)
#6 - 20x3/8" Screws
FIGURE 10
FIGURE 9
www.classicautoair.com • 866.435.7801 • PAGE 5
FIGURE 7
Retain all the OEM parts that
you remove, at least until the
installation is completed.