Freezer (All Units); Automatic Ice Maker - Viking F20603 Use & Care Manual

Built-in refrigerator/freezer
Table of Contents

Advertisement

Freezer
(all units except bottom-mount)
Wire Shelf Adjustment
You can easily adjust your freezer's
shelves. To remove a shelf, simply
tilt it up at the front, releasing the
hooks from the shelf support. Then,
pull the shelf straight out. To
replace, guide the rear hooks of the
shelf into the slots in the shelf
supports. Then, tilt the shelf up at
the front until the hooks drop into
the slots. Next, lower the front of
the shelf to a level position.
Wire Basket Adjustment
(all freezer model only)
You can easily adjust your freezer's
wire baskets by moving the
dividers. To remove a divider,
simply grasp it in the center, and
pull the divider straight up. To
replace, guide the divider around
the basket wires in the desired
location, then push the divider
down until it stops.
24

Automatic Ice Maker

The ice maker and slide-out ice drawer on your refrigerator are
not adjustable, but the ice drawer slides forward for easy access
to ice.
After the refrigerator reaches normal temperature, the ice
maker fills with water and begins operating. Under normal
conditions, the ice maker will produce seven to nine batches of
ice per 24 hour period.
NOT : Allow 24 to 48 hours after installation before looking for
ice in your ice drawer. You should discard the first three
full drawers of ice produced by your refrigerator, and should
also throw out the first drawer full of ice your refrigerator
produces after extended periods of non-use.
During ice production, the ice maker
arm raises and lowers. When the ice
bin is full, the ice maker arm
automatically turns the ice maker off.
To manually stop ice production, raise
the ice maker arm. You will hear a
definite click when you have the arm
in the right position. The ice maker
won't produce any more ice until you
push the ice bin all the way back into
place.
C UTION
To avoid damage to ice maker, observe the following:
• Do not force ice maker arm down or up past stop position.
• Do not place or store anything in ice bucket.
Ice Bin Adjustment
(all freezer model only)
Ice bins can be adjusted to match the way you use your freezer.
The ice bin on the left-hand side is used for collecting ice from
the ice maker. Once the left-hand ice bin is full, the bins can be
reversed so additional ice is made. If the ice maker is not
operating, the ice bin can be used for cold storage.
25
(all units except all refrigerator)
On
Position
Ice
Maker
Arm
Off
Position

Advertisement

Table of Contents
loading

This manual is also suitable for:

Built-in refrigerator/freezer

Table of Contents