Table of Contents
Advertisement
Features
1. Carrying strap
2. Speed control knob
3. On/off switch
4. Collection bag handle
5. Collection bag
6. Blow clamshell
7. Blow tube
8. Scraper
9. Vacuum tube - lower
10. Vacuum tube - upper
11. Locking ring
12. Release button
13. Powerhead
Assembly
Warning! Before assembly, make sure that the appliance is
switched off and unplugged.
Vacuum tube assembly (fig. A)
The vacuum tubes must be assembled together before use.
Warning! Do not operate the appliance with the vacuum
tubes separated.
To ease assembly, apply a soapy water solution to the
joint area.
Align the notches (15) and the triangles (14) on the
upper (10) and lower (9) vacuum tubes.
Push the lower vacuum tube (9) firmly into the upper
vacuum tube (10) until the triangles click into place.
Warning! Do not separate the tubes once assembled.
Blow tube assembly (fig. B)
The blow tube must be assembled to the blow clamshell
before use.
Align the circles (16) on the blow clamshell (6) and the
blow tube (7).
Push the blow tube (7) firmly onto the blow clamshell (6)
until the circles click into place.
Warning! Do not separate the tubes once assembled.
Carrying strap assembly (fig. C - D)
Fit the carrying strap (1) to the appliance and adjust to suit
the user.
Clip the hook (17) through the eyelet (18).
Adjust the length of the loop with the buckle (19).
Residual risks
Additional residual risks may arise when using the tool which
may not be included in the enclosed safety warnings. These
risks can arise from misuse, prolonged use etc.
8
Even with the application of the relevant safety regulations
and the implementation of safety devices, certain residual
risks cannot be avoided. These include:
Injuries caused by touching any rotating/moving parts.
Injuries caused when changing any parts, blades or
accessories.
Injuries caused by prolonged use of a tool. When using
any tool for prolonged periods make sure you take
regular breaks.
Impairment of hearing.
Health hazards caused by breathing dust developed
when using your tool (example:- working with wood,
especially oak, beech and MDF).
Use
Switching on and off (fig. E)
Warning! Use both hands to grip the product firmly when
switching on.
To switch the appliance on, slide the on/off switch (3)
forward.
To switch the appliance off, slide the on/off switch (3)
back.
Variable speed control (fig. E)
For extra control, your blowvac is fitted with a speed
control knob (2) located on the handle of the
powerhead.
Set the variable speed control knob (2) to the required
speed range.
Cable restraint (fig. F)
A cable restraint (21) is incorporated into the rear of the
powerhead.
Loop the cable (20) through the cable restraint (21).
Using your product (fig. G)
Warning! When using as a blower or vacuum, always wear
safety glasses. If using in dusty conditions, wear a filter mask
as well.
Warning! Switch off your product, allow the fan to stop and
remove the plug from the socket before carrying out any
adjustment, servicing or maintenance.
Blow mode (fig. G H and I)
Note: Make sure that the locking ring is in the unlocked
position (fig. I).
Attach the blow clamshell (6) and tube (7) to the
powerhead (13) (Fig. G) by locating the blower as
indicated by the arrow, then pivot about this point and
press the locking/release catch (12) until catch (22) is
fully engaged.
- Quick Links:
- Intended Use
- Troubleshooting
Hide quick links:
Advertisement
Table of Contents
