Power - JVC GR-DF450 Instructions Manual

How To Attach The Core Filter
Attach the core filters to the cables. The core
filter reduces interference.
1
Release the stoppers on both ends of the
core filter.
Stopper
2
Run the cable through the core filter, leaving
approx. 3 cm (1-3/16") of cable between the
cable plug and the core filter.
Wind the cable once around the outside of the
core filter as shown in the illustration.
Core filter
3 cm (1-3/16")
3
Close the core filter until it clicks shut.
NOTES:
Take care not to damage the cable.
When connecting a cable, attach the end with the
core filter to the camcorder.

Power

This camcorder's 2-way power supply system
lets you choose the most appropriate source of
power. Do not use provided power supply units
with other equipment.
Charging The Battery Pack
BATT. RELEASE
Battery pack
Wind once.
Power switch
1
Set the Power Switch to "OFF".
2
With the arrow on the battery pack pointing
right, push the battery pack slightly against the
battery pack mount a.
3
Slide the battery pack to the right until it locks
in place b.
4
Connect the AC Adapter to the camcorder.
5
Plug the AC Adapter into an AC outlet. The
POWER/CHARGE lamp on the camcorder
blinks to indicate charging has started.
6
When the POWER/CHARGE lamp goes out,
charging is finished. Unplug the AC Adapter
from the AC outlet. Disconnect the AC Adapter
from the camcorder.
GETTING STARTED
Arrow
Battery pack mount
POWER/CHARGE lamp
To AC outlet
CONTINUED ON NEXT PAGE
13
EN
Open the
cover.
To
DC connector
mark
AC Adapter