When connecting the camcorder to a PC
using a DV cable, make sure to follow the
procedure below. Connecting the cable
incorrectly may cause malfunctions to the
camcorder and/or the PC.
Connect the DV cable first to the PC, and then
to the camcorder.
Connect the DV cable (plugs) correctly
according to the shape of the DV connector.
[A] Using USB cable (GR-DF560/460 only)
It is possible to do the following things:
Transfer still images stored on a memory card
to a PC.
Transfer still/moving images recorded on a
tape to a PC.
[B] Using DV cable
It is also possible to transfer still/moving images
on a tape to a PC with a DV connector by using
the provided software*, software equipped with
the PC or commercially available software.
If you are using a Windows
®
Windows
Messenger to conduct video
conferences over the Internet, using a
camcorder. For details, refer to the help for the
®
Windows
Messenger.
NOTES:
Refer to "SOFTWARE INSTALLATION AND PC
CONNECTION GUIDE" for the bundled software
and drivers.*
It is recommended to use the AC Adapter as
the power supply instead of the battery pack.
(
pg. 15)
Never connect the USB cable and the DV
cable simultaneously to the camcorder.
Connect only the cable you wish to use to the
camcorder.*
When using a DV cable, be sure to use the
optional JVC VC-VDV206U or VC-VDV204U DV
cable depending on the type of DV connector
(4 or 6 pins) on the PC.
If the PC connected to the camcorder via the USB
cable is not powered, the camcorder does not
enter the USB mode.*
The date/time information cannot be captured into
the PC.
Refer to the instruction manuals of the PC and
Software.
The still images can also be transferred to a PC
with a DV connector-equipped capture board.
®
XP, you can use
The system may not work properly depending on
the PC or capture board you are using.
For GR-DF560/460 owners:
"USB" appears on the LCD monitor while the
PC is accessing data in the camcorder or the
camcorder is transferring a file to the PC.
NEVER disconnect the USB cable while
"USB" is displayed on the LCD monitor
since this can result in product damage.
* GR-DF560/460 only
Audio Dubbing
The audio track can be customised only when
recorded in the 12-BIT and SP modes.
(
pg. 38)
Use the provided remote control.
Speaker
START/
STOP
PAUSE
REW
PLAY
STOP
INSERT
A.DUB
1
Play back the tape to locate the point where
editing will start, then press PAUSE (9).
2
While holding A. DUB (D) on the remote
control, press PAUSE (9). The "9D" and "MIC"
indicators appear.
3
Press PLAY (U), then begin "narrating".
Speak into the microphone.
To pause dubbing, press PAUSE (9).
4
To end Audio Dubbing, press PAUSE (9),
then STOP (8).
EDITING
55
EN
Microphone Connector
Stereo Microphone
CONTINUED ON NEXT PAGE