Table of Contents
Advertisement
· Remove the paper feed guide from the
auto cutter assembly.
(1) Pull out the paper feed guide in
an arrow-indicated direction.
· Remove a paper gate from the auto
cutter assembly.
(1) Using the Phillips screwdriver,
remove 4 screws(PHT, M2 x 3)
used to secure the paper gate.
(Note) There are bosses(4 places) on
the cutter side.
to them when tightening the
screws at assembly.
6. Remove a roller holder.
(1) Using the Phillips screwdriver,
remove screws(binder, M2.6 x 6).
(2) Remove the roller holder from
the case.
· Remove a roller from the roller holder.
(1) Expose
the
section of the roller holder to the
outside to remove a roller.
Pay attention
roller
receiving
9
-
-
CBM-290/291 Service Manual
CITIZEN
Advertisement
Table of Contents
