JVC GR-AXM900 Instructions Manual page 61

In case of "SELECT"
<
N EXT DELETE
01 02
04 05
If you check the remaining still images on
Index Menu Screen after deleting...
<
NEX T INDEX
01 02
04 05
>
03
06
>
03
06
ACCESS DELETE EXECUTE MENU
SCREEN
5
Rotate the MENU Jog Dial to move the highlight bar
to "CANCEL" or "ENTER", then press it.
•"CANCEL" does not delete the selected still images
and the screen returns to the Menu Screen.
•"ENTER" deletes the selected still images. While
"ENTER" blinks, they are in the process of being
deleted from memory. After deleting is finished,
the screen returns to the Menu Screen.
CLOSE MENU
6
Press the MENU Jog Dial again to exit the Menu
Screen.
CAUTION:
While "ENTER" is selected on the Delete Execute
Menu and it is blinking, switching off the camcorder
or removing the power supply unit (battery pack or AC
Power Adapter/Charger) may cause the camcorder's
built-in memory to become corrupt. Never remove
the power supply unit at this stage.
NOTES:
Before deleting some still images stored in memory,
perform "Protect" for the necessary ones (
save them on a PC so that you do not lose them
accidentally ( pg. 63).
Even if "ALL" is selected on the Delete Menu Screen, it
is not possible to delete a still image with a padlock
mark. "ALL" only deletes all still images that are not
protected. After images are deleted from memory, the
remaining images are automatically moved up to fill in
any gaps in the numerical sequence. The Index No. for
images protected (with the padlock mark) may therefore
change.
When selecting the desired still image in step 4, to
move the frame from No. 7 to 6, place the highlight bar
on "EXIT" by rotating the MENU Jog Dial upward.
Rotate it further upward to move the frame to No. 6.
Perform the same procedure for still images that follow
the 13th one.
On the Delete Select Menu Screen, a star mark is
displayed next to a still image you shot in the FINE
mode.
61
EN
pg. 59) or