Internal Structure - Audi A6 2005 - Electrics Service Training

Internal structure

The pivot angle is monitored by an inductive pickup
in the pivot module. The pickup value is evaluated
immediately in the relevant power module for
headlights as a pulse width-modulated signal.
If the motor or pickup does not function, the power
module sends an error message to the control unit
for headlight range control J431.
This is communicated to the driver in a display in
dash panel insert J285.
The same lamps that are used in the bi-xenon
headlight are also used in the adaptive light
headlight.
CAN Communication
The values marked with (*) are used as input
variables in calculating the pivot angle.
All other input variables are only needed for
dynamic headlight range control.
Control unit for headlight range control
J431
Steering-angle sensor G85
Steering wheel angle*
Steering wheel angle speed*
Control unit for ABS with EDL J104
Wheel speeds*
Directions of travel*
Brake light switch signal
Yawing speed*
Brake pressure
Gas discharge light L13/L14
Control motor for dynamic
cornering light V318/V319
Magnet for headlight cover adjustment
N395/N396
Data bus diagnosis
interface J533
326_135
Sensor for pivot module
position G474/G475
Control unit for on-board power supply
J519
Dipped beam on*
Control unit for access and
start authorisation J518
Terminal X
Terminal 50
326_079
35