Related Manuals for Cloud WP-8
Summary of Contents for Cloud WP-8
- Page 1 WP-8 Installation Guide V4.0 Cloud Electronics Limited 140 Staniforth Road, Sheffield, S9 3HF England Tel +44 (0) 114 244 7051 Fax +44 (0) 114 242 5462 E-mail info@cloud.co.uk Web site http://www.cloud.co.uk...
-
Page 2: Table Of Contents
Wiring a WP-8 to a Pump/Sub Station 16-R.......3 Wiring a WP-8 to Low Power Speakers ........3 Controlling a Pump Station 16 Line Output with a WP-8....3 Providing a Line Level Output from a WP-8 .......4 Wiring a WP-8 to Powered Speakers.........4 Wiring a WP-8 to a Sub Station 16..........4... -
Page 3: Introduction
Note: These instructions are guidance only; always follow the instructions supplied with the assembly tool The WP-8 is fitted with a 3.5mm stereo jack socket that will accept a pair of stereo headphones. We recommend the use of headphones with an impedance of 32 ohms for example, the Cloud CP-32. -
Page 4: Wiring A Wp-8 To A Pump/Sub Station 16-R
PA system, perhaps for background music purposes. When this output is to be used, a WP-8 can be connected to channel 16 to control the music signal level and the music source selection. When a WP-8 is used for this purpose, it is not necessary for any headphones or speakers to be connected. -
Page 5: Providing A Line Level Output From A Wp-8
Switchable Line Level Output (mono) Wiring a WP-8 to Powered Speakers The output of a WP-8 can be used to drive a pair of powered speakers if extra volume is required. The diagram below shows how this can be achieved. -
Page 6: Wp-8A Information
Page 5 WP-8A Information The WP-8A has identical operation to that of the WP-8 but has been designed to fit single US electrical outlets only. A diagram of the WP-8A can be seen below: Should you require further help, please contact our technical support staff...
Need help?
Do you have a question about the WP-8 and is the answer not in the manual?
Questions and answers