Superior VCM3026ZMP Installation And Operation Instructions Manual page 16

For Built-In Installation
WARNING: A licensed elec-
trician must connect the wiring
harness to electrical supply
following all local codes. Electri-
cian must provide a clamp on the
box cover to secure the wiring.
Wiring should be routed through
the bushing in the hole on the
outer casing of fireplace.
1. Install a snap bushing found in hardware
kit into one of the holes on rear of valve
cover shield. The other hole is for a strain
relief clamp (not supplied) to secure in-
coming electrical supply.
Figure 19 - Wiring Diagram For Blower Accessory Built-In Installation
Extension Cord
Use extension cord if needed. The cord must
have a three-prong, grounding plug and a
three-hole receptacle. Make sure cord is in
good shape. It must be heavy enough to carry
the current needed. An undersized cord will
cause a drop in line voltage. This will result in
loss of power and overheating. Use a No. 16
AWG cord for lengths less than 50 feet.
16
INSTALLATION
Continued
110/115
V.A.C.
Black
White
Green
www.SuperiorFireplaces.US.com
2. Follow steps 2 through 6 in Installing
Blower Accessory, page 14.
3. A licensed electrician must follow the wir-
ing diagram to connect incoming electri-
cal supply to fan kit wiring harness (see
Figure 19).
4. Plug power cord to the outlet receptacle
(not provided) as shown in Figure 20.
Wind the extra power cord and tie with
plastic wire strap (see Figure 20). Set the
power cord bundle between the burner
bracket and outer casing, away from the
burner.
5. Test to make sure the blower is working
properly.
6. Reinstall upper louver assembly (see Fig-
ure 15, page 14) and close lower louver.
Fan Switch
(Auto/Off/On)
Auto
1
2
Off
3
Blue
On
Red
Blower
Bracket
Assembly
Screw
Switch
Switch
Plate
Red
Black Blue
Wire Harness
Plastic Wire Strap
Figure 20 - Installing Blower Bracket
Thermostat
Switch
(N.O.)
Blue
Blower
Motor
Red
White
Green
Wire
Harness
Power Cord
Outlet
Receptacle
(not included)
Lower Louver Door
Assembly
Clamp
Connector
(not
included)
126872-01A