Shooting While Watching The Viewfinder; Stop Recording - JVC GR-AXM1U Instructions Manual

16
POWER
Start/Stop
Power indicator
viewfinder
Tape remaining time
indicator
120MIN 119MIN
1MIN (Blinking)
0MIN (Blinking)
* MIN.....(Now calculating)
RECORDING

Shooting while watching the viewfinder

LENS COVER
Before the following steps, perform step 1 (
Switch
ENTER RECORD–STANDBY MODE
2
Make sure the LCD monitor is closed and locked.
Slide the LENS COVER open/close switch to open
the lens cover, then set the power switch to
CAMERA.
•The power indicator lights and the camcorder
•The scene you're aimed at appears on the
START SHOOTING
3
Press the Recording Start/Stop button.
•The tally lamp lights while recording is in progress,

STOP RECORDING

4
Press the Recording Start/Stop button again to stop
recording.
•The camcorder re-enters the Record-Standby
NOTES:
3MIN
When the power switch is set to CAMERA and the LCD
monitor is opened at an angle of 60 degrees or more, the
2MIN (Blinking)
LCD monitor switches on and the viewfinder switches
off automatically to save power.
A cassette holder can't be opened unless a power supply
is attached.
There may be a delay after you press EJECT until the
holder opens. Do not use force.
The tape's remaining time is displayed in the LCD
monitor or the viewfinder as shown.
The indicated remaining time is approximate.
The time required to calculate the remaining tape length,
and the accuracy of the calculation, may vary according
to the type of tape used.
Tally lamp
The tape remaining time indicator is correct only if the
correct tape length has been selected (
"TAPE END" appears when the tape reaches its end, and
the power goes off automatically if left in this condition
for 5 minutes. "TAPE END" also appears when a cassette
whose tape is already at its end is loaded.
If the Record–Standby mode continues for 5 minutes, the
camcorder's power shuts off automatically. Set the
power switch to POWER OFF, and then back to
CAMERA to turn the camcorder on again.
If you're recording on a cassette from the middle, use the
RETAKE function (
recording so you don't erase any of it.
The LENS COVER warning blinks for about 5 seconds
when the camcorder is turned on, whether the cover is
open or closed.
While shooting, sound is not heard from the speaker.
Basic Recording (cont.)
enters the Record–Standby mode.
viewfinder screen, with the word "PAUSE"
superimposed upon it.
and " REC " appears in the viewfinder.
mode.
pg. 18) to find the end of the last
pg. 15).
pg. 11).