Recording; Basic Recording - JVC GR-AXM1U Instructions Manual

RECORDING

Basic Recording

POWER
Start/Stop
Power indicator
PUSH/OPEN
LCD monitor
Tape remaining time
indicator
120MIN 119MIN
1MIN (Blinking)
0MIN (Blinking)
* MIN.....(Now calculating)
Tally lamp
NOTE:
LENS COVER
You should already have performed the procedures listed
Switch
below. If not, do so before continuing.
Power (
Tape Length/Recording Mode Setting (
Grip Adjustment (
LOAD A CASSETTE
1
First press PUSH/OPEN and open the LCD monitor
to an angle of over 60 degrees.
Press EJECT to open the cassette holder, then insert
the cassette with the label facing out. Press PUSH to
ensure the holder is closed and locked.
Shooting while watching the LCD monitor
ENTER RECORD–STANDBY MODE
2
Make sure the LCD monitor is fully open. Slide the
LENS COVER open/close switch to open the lens
cover, then set the power switch to CAMERA.
•The power indicator lights and the camcorder
•The scene you're aimed at appears in the LCD
START SHOOTING
3
Tilt the LCD monitor upward/downward for best
viewability (
Start/Stop button.
•The tally lamp lights while recording is in progress,
STOP RECORDING
4
Press the Recording Start/Stop button again to stop
recording.
3MIN
•The camcorder re-enters the Record-Standby
2MIN (Blinking)
NOTES:
When you use the LCD monitor outdoors in direct
sunlight, the LCD monitor may be difficult to see. If this
happens, we recommend that you use the viewfinder
(
For other notes, refer to pg. 16.
pg. 8)
pg. 13)
enters the Record–Standby mode.
monitor, with the word "PAUSE" superimposed
upon it.
pg. 17) and press the Recording
REC
and " " appears in the LCD monitor.
mode.
pg. 16).
15
pg. 11)