18 4 2 Sewing With Fullness; 18 4 3 Switching Between Smooth Sewing And Fullness; 18 4 4 Sewing With 8 Programmed Fullness Sequences - DURKOPP ADLER 275 Instruction Manual

6. 8.4.2 Sewing with fullness
When the machine is switched on press one of the keys from 1 to 8 (e g
sequence 1 is activated and the green LED above key 1 lights up
sequences (e g from 2 to 8) must be deactivated (the red LEDs must light up)
procedure is as follows:
press and hold down the on/off key
briefly press all the keys of the fullness sequences that are not required
(e g from 2 to 8) one after the other
as each key is pressed the red LED above it is switched on
pressing a key again reactivates the sequence, and the red LED goes out
release the on/off key
The current overfeed length of the active fullness sequence is shown in the display
If the result is not satisfactory, the overfeed length can be changed with the +/- keys
until a satisfactory result is obtained
saved
6. 8.4.3 Switching between smooth sewing and fullness
If you wish to keep switching between smooth sewing and fullness, proceed as follows:
Simultaneously press the “smooth sewing” key and the required fullness key
(key 1 to 8) The green LEDs above both keys light up
The switch between smooth sewing and the activated fullness takes place when the
knee switch is operated or when the thread is cut (see also section 6 18 5 )
Pressing the “smooth sewing” key switches this work mode off again
6. 8.4.4 Sewing with 8 programmed fullness sequences
When the machine is switched on the last fullness program to be used is briefly
displayed and activated
If this does not happen, the required sequence must be switched on by pressing the
key The applicable overfeed length is shown in the display After the first fullness
sequence has been sewn the next sequence is activated by operating the knee switch
or when the thread is cut (see also section 6 18 5 )
If the required fullness in a sequence is not obtained, the overfeed length be changed
by pressing the +/- keys
After the 8th fullness sequence control passes automatically to the 1st fullness
sequence
Sewing with less than 8 programmed fullness sequences.
If less than 8 fullness sequences are required in a seam, the fullness sequences not
required must be deactivated
press and hold down the on/off key
briefly press all the keys of the fullness sequences that are not required
one after the other
as each key is pressed the red LED above it is switched on
pressing a key again reactivates the sequence, and the red LED goes out
release the on/off key
The altered overfeed-length setting is immediately
The green LED above the current fullness sequence lights up
If the next sequence is then switched on, the change is saved
The procedure is as follows:
key 1): fullness
All other fullness
The
%
*