FAFCO 500 Series Installation Manual page 33

PV Panel Kit
Tile Roof Installation (Continued)
Step 5: Seal And Secure Angle
Place a nickel size
daub of roof seal-
ant at each hole.
Replace angle and
secure to tiles with
two 1/4" x 1-1/4"
concrete screws.
Step 7: Secure Lower Angle Mount
Repeat procedure for
lower angle mount.
Step 9: Connect PV Wire To Panel
Run PV panel wires
alongside roof sensor
wire under roof jack
into attic. Run 50' PV
wire from ICM, along-
side sensor wire, and
connect to PV panel
wire in attic with wire nuts. Connect positive to
positive and negative to negative.
Step 6: Place Lower Angle Mount
Hold lower angle
mount in place
against lower end
of panel and lay
panel in place
against upper
angle mount.
Step 8: Secure PV Panel To Angles
Lay panel inside an-
gles with wire protrud-
ing toward upper roof
jack. Attach with (4)
#14 x 1" self-tapping
screws.
Step 10: Connect PV Wire To ICM
Connect the 50' PV
wire to the controller
terminal block. Con-
nect positive to posi-
tive and negative to
negative.
32