Table of Contents
Advertisement
44
COUNTER R/M
POWER
w
M – 0 : 1 2 : 3 4
Viewfinder
RM-V705U (provided)
Insert Editing
You can record a new scene into a previously recorded
tape, replacing a section of the original recording with
minimal picture distortion at the in- and out-points. The
original audio remains unchanged.
NOTE:
Use the RM-V705U remote control unit to perform this
procedure.
1
2
3
Insert editing
4
indicator
Tape Counter
5
6
7
PLAY
NOTES:
PAUSE
REW
INSERT
EDITING (cont.)
SELECT MODE
Set the Power switch to "PLAY".
FIND EDIT-OUT POINT
Locate the point and press PAUSE on the camcorder
or the remote control.
RESET COUNTER
Press and hold COUNTER R/M for more than
2 seconds to reset the tape counter, then press for
less than 1 second and make sure "M" appears in
the viewfinder.
FIND EDIT-IN POINT
Press REW to go a little beyond the beginning of the
scene you want to replace, press PLAY to view the
recorded tape, and press PAUSE at exactly at the
point where the new scene should start.
ENGAGE INSERT EDITING MODE
Press and hold INSERT, and without releasing
INSERT, press and release PAUSE. The Insert
mode is engaged, and the scene the camcorder is
aimed at appears on the screen.
BEGIN INSERT EDITING
Press RECORDING START/STOP. When the counter
reaches "0:00:00", editing stops automatically and
the camcorder enters the Insert-Pause mode.
END INSERT EDITING
Press STOP.
•If a Fade/Wipe effect was in use during Insert
Editing, wait about 10 seconds after pressing STOP
before performing other operations.
After step 5, Retake (
pg. 18) can be performed.
The tape may stop slightly before or after the
designated end point, and noise bars may appear.
Neither indicates a defect in the unit.
Only video signal is recorded in the Insert Editing
mode.
Advertisement
Table of Contents
