Advertisement
Quick Links
Advertisement
Related Manuals for Syntace W-SERIES
Summary of Contents for Syntace W-SERIES
- Page 1 WHEELSETS W-SERIES HUBS HiTORQUE with Syntace MicroAdjust Caps...
-
Page 2: Intended Use
Enduro style riding. The Syntace wheels are not intended for use in Freeride and Downhill applications. If you wish to use the Syntace wheels in such an application you will have to accept that they are less dent resistant than conside- rably heavier rims which are specifically intended for these applications. - Page 3 • Assemble brake rotors and cassette (grease freewheel body!) according to manufacturer’s instructions. • Now you can put the wheels in your bike. Please take note of the Syntace Hi-Torque hub owner’s manual as well as the manufacturer’s instructions from your selected skewers or through axles.
- Page 4 • Syntace W35: Tesa strapping tape 4289 30mm width, or Yellowtape 25mm overlapping* • Syntace W40: Tesa strapping tape 4289 30mm width overlapping, or Yellowtape 25mm overlapping* *For W35 and W40 the 25mm Yellowtape can be used. However, it is to be applied in two overlapping layers so that the entire rim bed is covered, one layer to the right rim wall and the other to the left rim wall.
-
Page 5: Tyre Pressure
Syntace Disc Shims are recommended for aligning the brake rotor. They will allow perfect alignment of your rotor within the brake caliper.They are also useful for aligning the brake rotor in the same position on multiple wheelsets so no more brake drag is experienced or re-positioning of caliper is neccesary. - Page 6 • Only compatible with disc brake rotors with a 6 bolt pattern. Assembly • All Syntace hubs are supplied ready for assembly. The axial play may need to be adjusted when first as- sembling in your bike. Exact procedure for this can be found in section „Adjust axial play“.
-
Page 7: Hub Configuration
0.1mm is always better than too much axial pressure on the bearings! All Syntace hubs use non stepped axles without spacer tubes between the bearings. This allows the correc- tion of the tolerances that add up when many components are assembled together which otherwise would not be possible. - Page 8 • A video of how to service the hubs can be found on the Syntace website: Syntace.com > support • Under normal conditions, remove the freewheel body twice yearly, clean and lubricate. Under frequent use this may be neccesary at shorter intervals.
-
Page 9: Warranty
The warranty does not apply to wearing parts or impacts to the rim etc. Further information to the process can be found on: www.syntace.com/warranty_handling Please take note: binding is always the most current owner’s manual as can be found on Syntace.de/support Your Syntace Team... - Page 11 Syntace HiTorque Cap Front 15 (pcs.) through axle 15x100 (#116696) Syntace Bearing Kit Front 15 28 Hole (2 pcs. 17x26x5mm) (#115385) Syntace HiTorque Cap Front 15 adjustable set 15x100 (#116641) Syntace HiTorque Cap Front 20 (pcs.) through axle 20x110 (#116672)
- Page 12 Please look for the newest updates of this manual at: Syntace.com > Support Syntace GmbH Dammweg 1 D - 83342 Tacherting Tel. +49 (0)8634 66666 Fax +49 (0)8634 6365 syntace@syntace.de Current: 04.04.2014...
Need help?
Do you have a question about the W-SERIES and is the answer not in the manual?
Questions and answers