WARNING! IF THE INFORMATION IN THIS MANUAL IS NOT FOLLOWED EXACTLY, A FIRE MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. FOR YOUR SAFETY Comfort Home Products, Inc. DO NOT STORE 12256 William Penn Hwy, Ste A OR USE GASOLINE OR...
TABLE OF CONTENTS PLEASE READ THE INSTALLATION & OPERATIONS INSTRUCTIONS BEFORE USING THIS APPLIANCE IMPORTANT: Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible electric shock, fire hazard and will void the warranty. Installation instructions....................2 General........................2 Locating Your Electric Fireplace................3...
IMPORTANT SAFETY INSTRUCTIONS PLEASE RETAIN THIS USER’S GUIDE FOR FUTURE REFERENCE When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to person, including the following: 12. To prevent fire, do not block air intakes or 1.
WARNING: Procedures and WARNING: Procedures and techniques, which, if not techniques, which, if not carefully followed, will result carefully followed, will expose in damage to the equipment the user to the risk of serious or personal property or may injury, illness or death. cause personal injury.
ASSEMBL Y INSTRUCTIONS NOTE: A complete electric fireplace heater should consist of two parts, the wooden mantle and the fireplace heater each packed in a separate carton. It is not recommended to use the fireplace heater without the wooden mantle. Unpack the fireplace heater and mantle. Remove all packing materials.
Page 6
Step 3: Attach the SIDE PANEL to the LEFT FRONT PANEL with 2 KD SCREWS. Attach the other SIDE PANEL to the RIGHT FRONT PANEL with 2 KD SCREWS. See Figure C. Step 4: Attach the LEFT and RIGHT SIDE PANELS to the BASE using 4 KD SCREWS (2 screws for each side).
Page 7
Step 7: Attach the UPPER FRONT PANEL in between the upper section of teh 2 FRONT PANELS with 6 KD SCREWS (3 screws for each side). See Figure G. Step 8: Attach 3 MOUNTING CLIPS onto the top of INSERT and lock in place with 3 SHORT KD SCREWS.
OPERATING INSTRUCTIONS Note: Ensure the circuit breakers for the power supply are turned on. The controls are located behind the grill below front glass and can be accessed by pulling the grill up from the top, forward and down. 1 500W 75 0W ON/OFF Lift front grill to access the switches.
SERVICE INSTRUCTIONS WARNING: Disconnect power WARNING: Do not exceed before attempting any 40 Watts per light bulb. maintenance or cleaning to Use of a higher rated bulb reduce the risk of fire, may result in a fire electrical shock or personal causing property damage injury.
INSTRUCTIONS FOR POWER This heater is for use on 120 volts only. The cord has a plug as shown at (A) in the following figure. An adapter as shown at (C) is available for connecting three-blade grounding-type plugs to two-slot receptacles. The green grounding lug extending from the adapter must be connected to a permanent ground such as a properly grounded outlet box.
Need help?
Do you have a question about the Kozy-World EF5524 and is the answer not in the manual?
Questions and answers