Basic Recording - JVC GR-AX777UM Instructions Manual

14
EN
Power Switch
Recording Start/Stop Button
2 5M I N
MIN 120MIN
(Now calculating)
0MIN 1MIN
(Blinking) (Blinking)
BRIGHT Wheel (models equipped
with LCD monitor only)
90
180
–
– – – – – – – 6 – – –
BR I GHT
To Adjust The Brightness Of The LCD Monitor
.... rotate the BRIGHT Wheel until the bright
level indicator on the display moves and
the appropriate brightness is reached.
: Suitable for standard recording using NO special effects or manual adjustments.
: Allows you to set recording functions using the menus for more creative capabilities.
OFF : Switches off the camcorder.
: Allows you to play back your recordings.
During shooting
Tape remaining
time indicator
(Approximate)
119MIN
2MIN 3MIN
(Blinking)
+
Power Switch Position
RECORDING
NOTE:
You should already have performed the procedures listed
below. If not, do so before continuing.
Power ( pg. 6)
Load A Cassette (
Recording Mode Setting (
Tape Length Setting (
Grip Adjustment (
Viewfinder Adjustment (
Shooting While Watching The Viewfinder
1
Make sure the LCD monitor is closed and locked
(models equipped with LCD monitor only). Press in
the tabs on the lens cap to remove it. Set the Power
Switch to " " or "
the camcorder enters the Record-Standby mode.
"PAUSE" is displayed in the viewfinder.
2
Press the Recording Start/Stop Button. "
in the viewfinder while recording is in progress.
To Stop Recording . . .
.... press the Recording Start/Stop Button. The camcorder
re-enters the Record-Standby mode.
Shooting While Watching The LCD Monitor
(models equipped with LCD monitor only)
1
Make sure the LCD monitor is fully open. Press in the
tabs on the lens cap to remove it. Set the Power
Switch to " " or "
the camcorder enters the Record-Standby mode.
"PAUSE" is displayed in the LCD monitor.
2
Tilt the LCD monitor upward/downward for best
viewability and press the Recording Start/Stop Button.
" " appears in the LCD monitor while recording is
in progress.
NOTE:
When you use the LCD monitor outdoors in direct
sunlight, the LCD monitor may be difficult to see. If this
happens, use the viewfinder instead.
To Stop Recording . . .
.... press the Recording Start/Stop Button. The camcorder
re-enters the Record-Standby mode.

Basic Recording

pg. 13)
pg. 12)
pg. 12)
pg. 8)
pg. 8)
". The power lamp lights and
". The power lamp lights and
" appears