Table of Contents
Advertisement
Figure 32
Glass Door Cleaning and Maintenance
Cleaning:
Do not remove or clean the glass door when hot. When cool,
the glass may be cleaned with a clean, soft cloth and a household glass
cleaner. For cleaning white condensation from the interior glass, use
a gas fireplace glass cleaner available from your dealer. Use of caustic
or abrasive cleaners may damage the glass. DO NOT spray commercial
glass cleaner with ammonia on the door and glass gasket as it may
dissolve the gasket glue.
Repair:
If the glass is broken in the glass door, the entire door (metal
frame, gasket and glass) should be replaced as a unit. This replacement
glass door is available from your IHP dealer. Do not use substitute parts
or materials. The glass is neo-ceramic and alternative types must not
be used.
NOTE: BE CAREFUL NOT TO SPRAY COMMERCIAL GLASS
CLEANER WITH AMMONIA ON GASKET AREA OF DOOR. AM-
MONIA WILL DISSOLVE GASKET GLUE.
See Detail B
Detail B
DETAIL B
SCALE 0.500
Fuel Conversion
Converting this appliance between natural gas and propane (LP) can be
accomplished by installing a gas conversion kit. Only a qualified service
technician should perform the conversion.
Gas Conversion Kits: Please see instructions provided with
conversion kit.
Blower Removal
Unplug the power supply cord from the electrical outlet prior to removing
the blower. The blower can be accessed through the back wall of the firebox.
Remove the insert face, glass door, log set and firebox liner panels. All of
these items are fragile so handle them with care. Next, remove the nine
allen head screws around the outside of the panel fastened to the back
wall of the firebox. Rotate the top of this panel toward the front, remove
the two wires connected to the blower and then lift the panel with the
blower attached out of the firebox. To reinstall the blower, repeat these
steps in the reverse order.
Electrical Requirements:
This appliance is equipped with an electronic valve and electronic pilot
ignition system (which can be switched from Intermittent to standing
pilot mode - see Page 19). External electrical 120 Volt power is required
to operate the blower system of this appliance and recommended to oper-
ate the burner system. This appliance is equipped with a battery backup
system in case of a power outage (see Battery Backup on Page 17 for
more information).
This appliance, when installed, must be electrically grounded in accordance
with local codes, or in the absence of local codes, the National Electrical
Code ANSI/NFPA 70 - latest edition. (See Operating Options for burner
ON/OFF switch information).
27
Advertisement
Table of Contents
