Manual White Balance Adjustment - JVC GR-AX270 Instructions Manual

White balance mode indicator
No indication MWB
(Auto)
SELECT
SET
PROGRAM AE select dial
NOTES:
To switch to automatic white balance
adjustment, press SET until the indication
disappears, or turn the PROGRAM AE select
dial to "AUTO LOCK".
Re-adjust the White Balance when the lighting
has changed, when the camcorder has been
turned on and off again, or when the PRO-
GRAM AE select dial's position has been
changed.
It is helpful to connect your camcorder to a
colour monitor when adjusting the white
balance ("Basic Connections"
When adjusted by putting coloured paper in
front of the subject in step 2 ("ADJUST
FOCUS"), this unit makes its colour tempera-
ture standard for automatic white balance. So
you can enjoy shooting with different colours.
For example, when adjusting with red, blue or
yellow colours, the image becomes the colour
which aproximates to green, orange or purple
respectively.
Manual White Balance Adjustment (M.W.B.)
This camcorder's Automatic Colour Temperature system
senses the colour temperature of the ambient lighting for
M.W.B.
automatic white balance adjustment. However, precise
colour adjustment is not possible under the following
MWB
conditions:
•When an object is in various shades of the same colour.
•When a predominantly red or brown object is being
shot outdoors.
In these cases, use the camcorder's built-in preset filters
for white balance adjustment.
SELECT MODE
1
Turn the PROGRAM AE select dial to any position
except AUTO LOCK.
SELECT FUNCTION
2
Press SELECT reapeatedly until "
SELECT WHITE BALANCE
3
Press SET (Manual White Balance) until the
required indication appears in the viewfinder.
"MWB" .... With a memorized personal White
"
"
" " ......... Light source is halogen or tungsten lamp
MWB sets the colour temperature for the subject's light
source so you can shoot with natural colours that are
unaffected by surroundings, even when there are
multiple subjects with different colour temperatures.
MWB
SELECT MODE
1
Turn the PROGRAM AE select dial to any position
except AUTO LOCK.
ADJUST FOCUS
2
Point the camcorder at a white, flat object such as a
sheet of white paper, and adjust focus manually
(
ADJUST WHITE BALANCE
3
Press SET until "MWB" appears, then press and hold
SET for more than 3 seconds.
pg. 29).
•"MWB" blinks in the viewfinder during adjust-
Balance setting (see below)
" ......... Outdoors on sunny day
" ........ Outdoors on cloudy day
pg. 19).
ment, then stops blinking but stays lit when
adjustment is complete.
23
" appears.
M.W.B.