Installing A Line Filter Or Dsl Filter - Uniden XDECT 6135BTU Series Owner's Manual

Bluetooth problems Possible solutions
The XDECT 6135BTU
won't pair with my
phone.
The XDECT 6135BTU
doesn't ring when my
mobile phone does.
The XDECT 6135BTU
paired with my
phone, but I can't
hear anything
through the handset.

Installing a line Filter or DSl Filter

A telephone line filter or DSL filter prevents services that use the phone
line from causing interference on your phone. To get a line filter, contact
your service provider or look in an electronics store.
Plug the filter into the telephone wall jack and plug the base into the
filter. Make a test call to make sure the noise is gone.
x Making sure your phone is in pairing mode. Check
your phone's manual for instructions on Bluetooth
device pairing.
x Making sure your phone supports the Bluetooth
hands-free profile.
x Making sure your phone is in range of the base.
x If XDECT 6135BTU appears in your mobile phone's
paired device list, remove it and try pairing again.
x Turn your phone off, then turn it on again. Repeat
pairing steps.
x Disconnecting the base AC adapter. Wait a few
minutes, then reconnect it. Repeat pairing steps.
x Checking the link order for that phone. In rare
cases, some mobile phones may not be linked as
the third or fourth mobile phone.
x Making sure your phone has Bluetooth turned on.
x Checking if the XDECT 6135BTU is on the paired
device list on your mobile phone and is in
connected status. If not, try pairing again.
x Making sure your phone doesn't connect with
other Bluetooth devices.
x Making sure your phone is in range of the base.
x Making sure the handset's ringer is not turned off.
(The base doesn't ring on mobile phone calls.)
x Adjusting the handset volume.
x Setting your mobile phone to transfer the audio to
a Bluetooth device. Check your phone's manual for
instructions on Bluetooth setup and options.
x Erase the Bluetooth pairing and repair the mobile
phone to the base again. To delete the Bluetooth
pairing, see page 13.
29