Exit Settings; Factory Reset; Coding Of Remote Controller; Delete Remote Controller - Profile Auto-dial User Manual

Note:
In setting status, press [
CALL
input.
The system default password is [8888].
Operating method: [XXXX] [#]
XXXX indicates the 4-digit password.
LCD display:

3.Exit Settings

Press [*] and [#] buttons, the main unit emits a long beep and exits
settings. The [SET] indicator goes out and the system returns to
disarm state.
Operating method: 【*】 【#】

4.Factory Reset

In disarm status, use keypad to input [95175308246] and press
[#] to confirm, all the LED indicators will be on for 2 seconds and
you will hear a long beep. The main unit gets all its settings cleared
and restores to its factory settings successfully.
Operating method: [95175308246]

5.Coding of Remote Controller

Extra remote controller has to be code to the alarm host in order to
perform normally. The one in the standard package has been coded.
In setup state, use keypad to input [20], input the remote controller
number [1~8], and then press [#] to confirm. The main unit emits a
long beep and you will hear "remote control coding". The [
indicator is on without flashing; press any button on the wireless
remote controller, the main unit makes a long beep and you will hear
"coding completed", [ ] indicator goes out, indicating the remote
controller succeeds in coding.
Operating method: [20] ð [A] ð [#]
5
Function Settings
] button can delete the numbers
[#]
]
Functions Settings
A indicates: 1~8 remote controllers number. You can add maximum 8
remote controllers.
LCD display:

6.Delete Remote Controller

The remote controller can't control the main unit after it's deleted.
In setup state, use keypad to input [21], then input the remote
controller number [1-8], and then press [#] to confirm. The main unit
emits a long beep and the [Signal] indicator flickers once. You will
hear a voice prompt "delete completed".
Operating method: [21] [A] [#]
A indicates: 1~8 remote controllers number.

7.Coding of Defense Zone

Wireless detectors have to be coded to the main unit in order to
trigger it alarm. The wireless PIR and door sensor in the standard
package have been coded.
In setup state, use keypad to input [23], input the defense zone
number you want to code [01~99], and then input [#] to confirm. The
main unit emits a long beep and the corresponding defense zone is
displayed on the screen. You will hear a voice prompt "detector
coding". Then trigger a wireless detector to emit a wireless signal;
after receiving the signal, the main unit makes a long beep, and you
will hear "coding completed", the [
time.
Operating method: [23] [XX] [#]
XX indicates: 01 ~99 defense zones number
LCD display:

8.Delete Defense Zone

The wireless detector can't control the main unit after it's deleted.
] indicator goes out at the same
6