External Devices - Seitz roundshot Instruction Manual

3.2.5 External device
Press the „External device" button in the „Parameter" menu to activate the Press the „External device" button in the „Parameter" menu to activate the
„External device" tab: „External device" tab:
This menu controls the connection of the software to any external device including the
camera. The external devices that can be connected to the camera are GPS and compass.
If the camera cannot be detected, open the network properties and check the settings.
It is important that the network uses a fixed IP in the same range (but not identical) as
the IP of the camera (digital scan back) and that both are located in the same subnet:
Instruction Manual Seitz 6x17 Digital - version 4.05 - May 2013- © by Seitz Phototechnik AG / Switzerland www.roundshot.ch
The tab contains the following options:
Camera: open the drop-down list to see all
the cameras present in the network:
• Refresh: click on "Refresh" to refresh the
camera list when connecting a new
camera
• Connect to camera: after selecting the
camera click on "Connect to camera". The
message "camera ready" should appear in
the message area (bottom right)
• Change IP: change the camera IP address
by clicking on "Change IP". After
refreshing the camera list it the new IP will
be displayed in the camera list.
Open network connections of your computer.
Open LAN connection.
Choose „internet protocol TCP/IP" and „properties".
Choose „fixed IP" and enter the following IP
address: 10.0.0.68
Subnet mask: 255.0.0.0
If you would like to connect to internet while working
with the camera, then set the same standard gateway
network IP as your network (i.e.192.168.178.xx), the
same subnet (for example 255.255.255.0) and the same
DNS server (for example 192.168.178.1). Ask your
system operator for assistance. Then change the
camera IP adress according to the subnet mask (for
example 192.168.178.yy)
page 38