Transport Limit Switch (3000 Hydroject Only); 2 Transmission Switches (3000 Hydroject Only) - Toro Hydroject 3000 Troubleshooting Manual

Aerators

Hide thumbs Also See for Hydroject 3000:

Table of Contents

TORO Hydroject® 3000/4000

Transport Limit Switch (3000 Hydroject® Only)

The transport limit switch signals the controller when the wheels are in the transport position.

In the transport position (wheels down) the switch is closed.

In the aerate position (wheels up) the switch is open.

NOTE:

On earlier units, there were 2 switches for this function.

2 Transmission Switches (3000 Hydroject® Only)

The top switch is normally open, and closes to enables the engine to start when the hydrostatic control is in the

neutral position.

The lower switch is normally closed and is connected to the controller. If the Hydroject® is pumping water and

the operator leaves the traction drive in neutral, this switch signals the controller to shut down the high-pressure

pump and the cycling valve after 4 seconds.

____________________________________________________________________________________________________________

NOTES

Components

Table of Contents

Show Quick Links

Table of Contents

Hydroject 4000