ProCurve 2610 Series Installation And Getting Started Manual page 43

■
RPS Device Connected LED
RPS Power: 12V backup to one connected device. Lowest-numbered port has priority.
R3
RPS 3 RPS 4
Figure 2-12. RPS/EPS status LEDs
The following states provide status of the RPS and EPS ports.
Fault (located on
600 RPS/EPS Connectivity
The following illustration shows an example of connectivity between an RPS/
EPS device and a switch device as a redundant AC power supply.
Power Status
RPS Power Status LED
R4 R5
RPS 5 RPS 6
Device
the front) Connected
Off Off
On or Off Off
Off On
Off On
Flashing Off
Off On
EPS Device Connected LED
!
EPS Power: 50V 370W total for PoE applications. Power is shared when
R6 E1 E2
EPS 1 EPS 2
Power Message
Status
Off Nothing Connected
On Not a valid state - should never happen
Off Switch is connected, RPS is available but
not required
On RPS is powering the connected device
Flashing RPS/EPS port is in fault condition
Flashing Switch is requesting power, RPS can not
provide it. (N/A for EPS)
Installing the Switch
Installation Procedures
EPS Power Status LED
both ports are used.
Device
Connected
Power
Status
Line: 50/60 Hz.
10 0 - 240 V~ 9.1A (9,1A)
2-23