Operating Characteristics Of The 610 Eps (J8169A); 600 Rps/Eps Leds - ProCurve 2610 Series Installation And Getting Started Manual

Installing the Switch
Installation Procedures
ProCurve 600/610 External Power Supplies Installation and Getting Started
Guide, which is on the ProCurve Web site at
(See
For redundant AC power, connect the 600 RPS/EPS to the switch using one
of the six supplied RPS cables. RPS cables are 1.25 meters (4.10 feet) in length.
For redundant or additional PoE power, connect the 600 RPS/EPS to the
switch using one of the two supplied EPS cables. EPS cables are 2.00 meters
(6.56 feet) in length.

Operating Characteristics of the 610 EPS (J8169A)

The 610 EPS does not have any RPS ports and can not supply RPS power. It
has four EPS Ports. You can connect one to four ProCurve PoE capable
switches to provide PoE power as a primary or backup source. Two in Pair A
and two in Pair B. Power is equally shared between the EPS ports in pair A
(that is, port A1 and A2) and between the EPS ports in pair B (port B1 and B2)
Each pair can provide a maximum of 408 watts of PoE power to a switch if
only one port is used. If the second port of a pair is used, then both ports supply
204 watts each. Again, it is important to understand the PoE power
requirements of the switches. For further information regarding the 610 EPS
PoE capabilities, see the PoE Planning and Implementation Guide, which is
on the ProCurve Web site at

600 RPS/EPS LEDs

For a complete description of the LEDs see the documentation that came with
the 600 RPS/EPS.
The 600 RPS/EPS LEDs are located on the back of the device. These LEDs are
duplicated on the front of the device for your convenience. The following
graphic shows an example of the back of the 600 EPS/RPS. There are two
green LEDs for each RPS and EPS port:
■
2-22
page 1-12).
Device Connected
www.procurve.com,
www.procurve.com,
(See page 1-12).