Operation; Starting The Trimmer - Toro 51484 Operator's Manual

3
Installing the Edge Guard
Parts needed for this procedure:
Insert the ends of the wire edge guard into the holes in the trimmer
housing, as shown in Figure 3.
g017642
1. Wire edge guard
4
Adjusting the Trimmer Height and Base
Orientation
No Parts Required
•
To adjust handle height, flip the auxiliary handle latch, slide it up
or down to the desired height, then secure it in place by closing
the latch (Figure 4).
1
Figure 3
1. Auxiliary handle
2. Auxiliary handle latch
•
To adjust the trimmer height, open the height adjustment latch,
then slide the shaft up or down to desired height, securing it in
place with the latch (Figure 4).
•
To adjust the orientation of the base, press down on the rotator
button located at the base of the shaft, then move the base to face
the desired direction (Figure 5).
1. Rotator button

Operation

NOTICE! The battery pack is not fully charged when it is
purchased. Before using the trimmer for the first time, place the
battery pack in the charger and charge until the LED indicators
turn green. Make sure to read all safety precautions. With regular
use, it will need shorter charging time. If storing for a prolonged
period of time, remove the battery. When ready to use again,
charge the battery pack until the LED indicators turn green.

Starting the Trimmer

1. Align the tongue of the battery pack with the cavity in the handle
housing (Figure 6).
4
G015655
Figure 4
3. Height adjustment latch
G017507
Figure 5