Operation - Toro 51370 Operator's Manual

Setup
Adjusting and Assembling
the Trimmer
1. Loosen the
knob (A), then move the
assist handle up or
down the shaft to your
desired height.
2. Pivot the assist
handle to a comfortable
position (B), then tighten
the knob.
3. Install the guard as
shown, snapping it into
both sides of the
trimmer.
The blade under the guard is sharp and can cut
you. Be careful when handling the trimmer so
that you do not accidentally cut yourself.
4. Install the metal wire guide.
B.
A.
m–6319
4
A
B
m–7852a
m-6314/6326
m–6327
3352-872

Operation

During operation, the trimmer may throw objects
in the operator's or a bystander's direction,
causing injury.
S
Wear safety goggles or other suitable eye
protection, long pants, and shoes while
operating the trimmer.
S
Keep bystanders away from the work area.
When the trimmer is running the cutting head is
spinning. If you contact the cutting line or cutting
head, you could be injured.
S
Keep the cutting head away from your hands,
feet, and bystanders. Keep the guard in place
and in working order.
S
Wear shoes and long pants when using the
trimmer.
S
Ensure that the cutting head has stopped and
you disconnect the trimmer from the power
source before you service or examine the
cutting head. Do not start the trimmer unless
your hands are on both handles and the
cutting head is down near the ground.
S
Do not allow the trimmer to cut into the cord.