Vaux Electronics Lattis 1600 Series Owner's Manual page 16

Routing audio using Route-Audio-Muted command (*CW,14,zon,ssa):
1) Routing a source when zone is currently off:
- Routes and places zone in muted state, and sets unmute volume to:.
2) Routing a source when zone is currently on (skipped if source is the same):
- Routes at current zone volume.
3) Routing a source when zone is currently muted:
- Routes and leaves zone in muted state.
- Unmute level will be previous volume (level when zone was muted).
Routing audio using Route-Audio-At-Volume command (*CW,15,zon,ssa,vvl,vvr):
1) Routing a source when zone is currently off:
- Routes and sets zone volume to specified volume level.
2) Routing a source when zone is currently on:
- Routes at specified volume level (if source is the same, just updates volume).
3) Routing a source when zone is currently muted:
- Routes and unmutes to specified volume level.
Routing audio using Route-Audio-At-Vol-Muted command (*CW,16,zon,ssa,vvl,vvr):
1) Routing a source when zone is currently off:
- Routes and places zone in muted state.
- Unmute level will be specified volume level.
2) Routing a source when zone is currently on:
- Routes at specified volume level (if source is the same, just updates volume).
3) Routing a source when zone is currently muted:
- Routes and leaves zone in muted state.
- Unmute level will be specified volume level.
a) Normal (factory setting) unmute level uses programmed "Zone-Initial-Volume."
b) Optionally, may configure unmute level to be "Previous" volume.
(this was level when zone was last turned off)
(the implementation actually updates Zone-Initial-Volume at every zone turn-off,
then this route-muted command loads unmute levels from initial).
NOTE: DOES NOT MUTE IF ZONE IS ON
NOTE: DOES NOT MUTE IF ZONE IS ON
16