Programming The System; Setting Each Zone's Initial Volume Level (And Maximum Level) - Vaux Electronics Lattis 1600 Series Owner's Manual

Programming the System

Setting each Zone's Initial Volume Level (and maximum level)

When you have the system running, you will likely wish to tailor each room's initial volume level (the level to which
it first turns on). You can also set the maximum volume of the amplifier at this point.
Note: The earlier RC-8-IR remote control may also be used to set this adjustment.
•
Set the RC-16 remote control so you are controlling the desired zone (01 to 90).
Press the Zone button, followed by two-digits corresponding to the desired zone.
eg: Zone-0-1 will select zone 01, and Zone-1-2 will select zone 12.
This zone is saved in the remote until you change it again.
•
Turn down power amp's level control for this zone to about 25%
•
Select a nominal-level source such as a CD or Tuner.
•
Using the RC-16 remote control, turn the zone's volume up to maximum.
•
Adjust the power amp's level control to the loudest level you wish the zone to reach.
•
Using the RC-16 remote, turn the volume down to the desired initial (turn-on) level.
•
Press Shift-FFwd on the RC-16 (Shift followed by the FFwd key).
•
Repeat for other zones.
10