Table of Contents
Advertisement
Accessories
1
2
3
†
4
†
†
5
†
This accessory is used when connecting an external device
to AV-IN jack on the front panel of this unit. For how to use
this accessory, refer to the instruction manual of this unit.
2
|
DDX630BT
Installation Procedure
1. To prevent short circuits, remove the key from the
ignition and disconnect the - terminal of the
battery.
2. Make the proper input and output wire
..........1
connections for each unit.
3. Connect the wire on the wiring harness.
4. Take Connector B on the wiring harness and
connect it to the speaker connector in your vehicle.
5. Take Connector A on the wiring harness and
..........1
connect it to the external power connector on your
vehicle.
6. Connect the wiring harness connector to the unit.
7. Install the unit in your car.
8. Reconnect the - terminal of the battery.
..........1
9. Press the reset button.
2WARNING
• If you connect the ignition wire (red) and the battery wire
(yellow) to the car chassis (ground), you may cause a short
circuit, that in turn may start a fire. Always connect those
..........2
wires to the power source running through the fuse box.
After the Installation
After the installation, perform the Initial Setup by
referring to the instruction manual.
..........1
Advertisement
Table of Contents
