Sabbath Mode; Baking And Roasting - Whirlpool Gas Range User Manual

Sabbath Mode

The Sabbath Mode sets the oven to remain on in a bake setting
until turned off.
When the Sabbath Mode is set, only the Bake cycle will operate.
All other cooking and cleaning cycles are disabled. No tones will
sound, and the displays will not indicate temperature changes.
When the oven door is opened or closed, the oven light will not
turn on or off, and the heating elements will not turn on or off
immediately.
To Enable Sabbath Mode Capability (One Time Only):
1. Press SETTINGS/CLOCK until "SABBATH" is displayed.
"OFF. Press (1) for On" will scroll in the display.
2. Press the "1" keypad. "ON. Press (1) for Off" will scroll in the
display. Sabbath Mode can be activated for baking.
3. Press START or CANCEL to exit and display the time of day.
NOTE: To disable the Sabbath Mode, repeat steps 1 through 3
to change the status from "SABBATH ON" to "SABBATH OFF."
To Activate Sabbath Mode:
1. Press BAKE.
2. Press the number keypad to set a temperature other than
350°F (177°C).
3. Press START.
For timed cooking in Sabbath Mode, press COOK TIME, and
then the number keypads to set the desired cook time. Press
START.
4. Press SETTINGS/CLOCK. Three tones will sound. Then
press "7." "SAb" will appear in the display.
To Adjust Temperature (When Sabbath Mode is Running):
1. Press the number keypad as instructed by the scrolling text to
select the new temperature.
NOTE: The temperature adjustment will not appear on the
display, and no tones will sound. The scrolling text will be
shown on the display as it was before the keypad was pressed.
2. Press START.
To Deactivate Sabbath Mode:
Press SETTINGS/CLOCK, and then press "7" to return to regular
baking, or press CANCEL to turn off the range.

Baking and Roasting

Preheating
When beginning a Bake, Convect Bake or Convect Roast cycle, the
oven will begin preheating after Start is pressed. The oven will take
approximately 12 to 15 minutes to reach 350°F (177°C) with all of
the oven racks provided with your oven inside the oven cavity.
Higher temperatures will take longer to preheat. The preheat cycle
rapidly increases the oven temperature. The actual oven
temperature will go above your set temperature to offset the heat
lost when your oven door is opened to insert food. This ensures
that when you place your food in the oven, the oven will begin at
the proper temperature. Insert your food when the preheat tone
sounds. Do not open the door during preheat before the tone
sounds.
Rapid Preheat
Rapid Preheat can be used to shorten the preheating time. Only
one standard flat oven rack should be in the oven during Rapid
Preheat. Extra racks should be removed prior to starting Rapid
Preheat. Press RAPID PREHEAT and follow the oven control
prompts, or, if preheating has already started, simply press RAPID
PREHEAT. The preheating cycle should be completed before
placing food in the oven. When the Rapid Preheat cycle is
complete, the oven starts a normal Bake cycle.
IMPORTANT: Rapid Preheat should be used only for one-rack
baking.
Oven Temperature
While in use, the oven elements will cycle on and off as needed to
maintain a consistent temperature, but they may run slightly hot or
cool at any point in time due to this cycling. Opening the oven door
while in use will release the hot air and cool the oven which could
impact the cooking time and performance. It is recommended to
use the oven light to monitor cooking progress.
NOTE: On models with convection, the convection fan may run in
the non-convection bake mode to improve oven performance.
®
ACCUBAKE Temperature Management System
The ACCUBAKE ® system electronically regulates the oven heat
levels during preheat and bake to maintain a precise temperature
range for optimal cooking results. The bake and broil elements or
burners cycle on and off in intervals. On convection range models,
the fan will run while preheating and may be cycled on and off for
short intervals during bake to provide the best results. This feature
is automatically activated when the oven is in use.
Before baking and roasting, position racks according to
"Positioning Racks and Bakeware" section. When roasting, it is not
necessary to wait for the oven preheat cycle to end before putting
food in unless it is recommended in the recipe.
FrozenBake™ Technology
FrozenBake™ Technology can be used to cook prepackaged
frozen food without needing to preheat the oven and without
overbrowning the food. There are 4 preprogrammed food options
to choose from: Pizza, Lasagna, Nuggets/Fries, and Pie.
FrozenBake™ Technology should only be used for these foods.
Cook only 1 package at a time when using FrozenBake™
Technology. Use the recommended temperature and maximum
recommended time from the packaging.
A beep will alert you to check the food's doneness before the cook
time is completed and again at the end of the cook time. The
display will prompt you to add to the cook time or end the cycle.
13