Usb Cd-Rw Installation Continued - Pacific Digital U-30109 User Manual

USB CD-RW Installation Continued

Step 10: The "Drivers" are located on the "Burner Bundle" CD (Drivers for the
USB 2.0 CD-Writer are located in X:\Drivers) (Replace X with your
drive letter where the "Burner Bundle" CD is located) Click "Next", then
Click "Finish".
Step 11: The Device Driver will be installed for your USB 2.0 CD-Writer. A new
drive letter for the USB 2.0 CD-Writer will appear in "My Computer".
Open "My Computer" and make sure the new drive's icon is visible.
Your drive is now ready for use.
Step 12: Install your recording software from the "Burner Bundle" CD that was
included with your USB 2.0 CD-Writer. This Software is Required in
order to create CDs.
NOTES:
NOTE: It is highly recommended that you install the USB 2.0
PCI card in order to utilize the full potential of your USB 2.0 CD-Writer.
NOTE: If you are not using the USB 2.0 PCI card supplied,
because of limitations in USB 1.1 technology, your USB 2.0 drive will
only be able to function as a 4x4x8 CD-Writer.
NOTE: If for some reason your don't install the USB 2.0 PCI
card into your computer, Connect the USB 2.0 cable to your USB 1.1
port. Your "Hardware Wizard" should find the USB 2.0 CD-Writer
(Make sure Power Toggle is turned ON). Select "Search for best driver",
Uncheck everything except "Specify a Location" Click "Browse" Select
your CD-ROM where the "Burner Bundle" is located Double Click the
"Drivers" folder and Click "Next" or "Finish"
11