Table of Contents
Advertisement
This may also happen if the Power Switch ( O / I ) was left in the ON ( I ) position
(lower position) after previous use and the unit was disconnected by unplugging only.
Make sure to turn the unit off after each use and then disconnect from the
electrical outlet so the unit is in the OFF ( O ) position when used next time.
4) Slowly pass over surfaces to be cleaned. Apply steam liberally. Keep a towel
handy and wipe away any excess water that may accumulate.
5) When the Hand-Held Steamer stops emitting steam, simply turn OFF and unplug
the unit, refill the Water Tank and continue cleaning.
To sanitize your work surfaces, kitchen countertops, sinks, bathrooms, etc., use
the Hand-Held Steamer over the same area for about 15 seconds.
!
NOTICE
Do not carry out this procedure on heat and steam sensitive surfaces.
The force and heat of the steam may adversely affect certain materials. Always
check the suitability of using the steamer on a particular surface by first testing
a hidden area.
!
WARNING
Never direct steam towards people, animals or plants.
!
NOTICE
•
Do not use the steam to clean frozen windows.
•
Be careful when using the steamer on glass, as it may break.
•
Do not use steamer on leather, wax polished furniture or waxed
floors, synthetic fabrics, velvet or other delicate steam-sensitive materials.
Thane Direct and its affiliated companies assume no liability for personal injury or
property damage resulting from the misuse of the H2O MOP X5™, including the
failure to comply with the instructions contained in this User Guide or provided by
the manufacturer or distributor of the treated surface.
USER'S GUIDE
20
21
3) Once the unit has been fully assembled and filled with water, plug in the Power
Cord to a grounded electrical outlet. The RED light - Power Indicator will indicate
when power is on. Power Switch ( O / I ) is in the OFF ( O ) position (higher position).
Wait for the Ready-to-Use indicator to turn Green - approximately 20 - 30 seconds.
GREEN light will turn on when the steam mop is ready for use.
When the Ready-to-Use indicator light turns Green press the Power Switch ( O / I )
to the ON ( I ) position (lower position). The mop will start emitting steam.
To stop emitting steam turn OFF ( O ) the unit by pressing the Power Switch ( O / I )
again.
If the Power Switch ( O / I ) is pressed
(lower position) prior to Ready-to-Use
light indicator turning green, water from
the previous use will not be heated
and will be forced out by present steam
and will cause puddling to occur.
This may also happen if the Power
Switch was left in the ON ( I ) position
(lower position) from the previous use
and the unit was disconnected by
unplugging only. Make sure to turn
the unit OFF after each usage and
then disconnect from the electrical
outlet so the unit is in the OFF ( O ) position when used next time.
4) Slowly pass over the surface to be cleaned. The absorbent mop cloth picks up
the dirt loosened by the steam. Apply steam liberally. Keep a towel handy and wipe
away any excess water that may accumulate.
5) When the H2O MOP X5™ stops emitting steam, simply turn OFF and unplug
the appliance, refill the Water Tank and continue cleaning.
USER'S GUIDE
USER'S GUIDE
Green - Ready to use
Red - Power ON
OFF (O)
ON (I)
Position
Position
(Higher)
(Lower)
20
14
Hide quick links:
Advertisement
Table of Contents
