Seat Inspection/Seat Belt Inspection/Wheel Aignment Inspection; Starting Condition Inspection; Exhaust System Inspection; Window Washe Inspection/Wiper Inspection - Subaru Forester 2003 Service Manual

PRE-DELIVERY INSPECTION
22.SEAT
Check that each seat provides full functionality in
sliding and reclining. Check all available functions
of the rear seat.
23.SEAT BELT
Pull out the seat belt and then release it. Check that
the belt webbing retracts smoothly.
24.WHEEL ALIGNMENT
Check the wheel alignments. <Ref. to FS-7, Wheel
Alignment.> and <Ref. to RS-9, Wheel Alignment.>
25.TEST MODE CONNECTORS
Turn the ignition switch to ON and check that the
check-engine light starts blinking. If the light blinks,
return the ignition key to LOCK and disconnect the
test mode connector. Then, turn the ignition key to
ON again. If the check-engine light blinks at that
time in spite of the disconnected test mode connec-
tor, carry out an engine diagnosis.
(A) Test mode connector (Green)
26.STARTING CONDITION
Start the engine and check that the engine starts
smoothly. If any battery voltage problems are
found, recharge or replace the battery. If any ab-
normal noises are observed, immediately stop the
engine and check and repair the necessary compo-
nents.
27.EXHAUST SYSTEM
Listen to the exhaust noise to see if no abnormal
noises are observed.
28.INDICATOR LIGHT
Check that all the indicator lights are off.
29.CLOCK
Check the clock for normal operations and enough
accuracy.
PRE-DELIVERY INSPECTION
(A)
PI-00076
30.RADIO
Check the radio for full functionality and normal
noise level. Also check the CD unit operations.
31.CIGARETTE LIGHTER
Check the cigarette lighter operations.
32.LIGHTING SYSTEM
• Check the headlight operations.
• Check the brake light operations.
• Check the other lights for normal operations.
33.WINDOW WASHER
Check that the window washer system injects
washer fluid to the specified area of windshield
shown in the figure.
Front injection position:
A: 350 mm (13.78 in)
B: 150 mm (5.91 in)
C: 275 mm (10.83 in)
D: 600 mm (23.62 in)
(1) Nozzle
Rear injection position:
A: 36 mm (1.42 in)
B: 72°
(1) Nozzle
34.WIPER
Check the front and rear wipers for normal opera-
tions.
PI-10
(A) (A)
(B) (B)
(D)
(C)
WW-00107
(1)
B
PI-00081
A