Test Running; Is The Unit Installed Correctly - Pridiom AOS090HR Installation Manual

High wall
Hide thumbs Also See for AOS090HR:
Table of Contents

Advertisement

*
Connection of power cable
1.Remove the drawer of the outdoor unit.
2.Connect the indoor power and control
wires with the matched outdoor wires in accordance
with the electric schematic diagram and make sure
that the connection is firmly done(Fig.7)
3.Use a press plate to fix the wires firmly,and re-install
the drawer.
Note:Do not connect the wires in a wrong way,otherwise electric malfunctions will be caused and
even damages to the units will occur.The appliance shall be installed in accordance with national
wiring regulation.If the supply cord is damaged,it must be replaced by the manufacturer or its service
agent or a similarly qualified person in order to avoid a hazard.The plug shall be accessible after
installing the appliance.If the model have not plug that a switch which have a contact separation
of at least 3 mm(1/10") in all poles shalled be added in fixed wiring.
*
Finishing touches
* Use thermal tube to wrap the joints and wrap the tube tightly with ethylene tapes.
* Fix the wrapped pipelines on the exterior wall with clamps.
* Fill in the gaps left over by the pipeline hole and wall hole to prevent rain-water from entering.
*

Test running

* Connect to the power source,check if the function selection keys on the remote controller are
working properly.
* Check if the room temperature adjustments and timer settings are working properly.
* Check if the drain is smooth.
* Check if there is any abnormal noise or vibration during operation.
* Check if there is leakage of refrigerant.
*

Is the unit installed correctly?

*Suitable Installation Position
*Isn't there anything which prevents ventilation or obstructs operation in front of the indoor unit ?
Do not install the unit following place .
*Inflammable gases may leak .
*Oil splashes a lot .
*In case where the unit is used in such places as poisonous or sultry gases are generated or seaside
district exposed to sea breezes corrosion may cause malfunction . Consult with your distributor .
*Air conditioner body and remote controller must be I m(39-3/4") or more away from a TV or a radio.
Drain the dehumidified water from the indoor unit to a place which drains well .
*Pay attention to operation noise
*When installing the unit , choose a place which can stand the weight of the unit well and does
not increase the operation noise or vibration . Especially where there is a possibility that vibration
be transmitted to the house , fix the unit by inserting attached vibration -proof pads between the
unit and fittings .
*
*
*
INSTALLATION & REPAIR GUIDE
Split Wall-Mounted air conditioner
Fig.7
*
11
wire pressing plate
Drawer
screw

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents